1.*5mm standard DIN rail installation, comply with DIN EN ****2.Or front boards setting (mounting holes center distance *3mm).Either is ok.
2.Pole 6 width (modulus *2.5mm) comply with standard JB/T********3
3.LCD display 6*1 digits (*****9.1kwh)
4.Standard configuration: impulse output passive (polarity).May select distant impulse output passive (no polarity). Contact with all kind of AMR system conveniently comply with standard IEC ******1 and DIN ****4
5.Two LED instructions: power supply state (green) and signal of energy impulse (red)
6.Standard configurations don’t detect the direction of load current. May select automatic detection the direction of load current and instructions by individual LED
7.Measuring single phase two wires active energy consumption in single direction is nothing with the direction of load current. Comply with standard IEC ********1.
8.Standard configuration: type S wiring (inlet from bottom, outlet from top) direct connect operation.
9.Standard configuration short terminals cover, select extension terminal cover in need of electricity safe.
