Factory direct high pressure hose Rubber Hydraulic pipe for Oil

详情

Specifications

The hose is oil resistance, heat resistance, aging resistance, and high bearing pressure, pulse performance
A, product structure types:

Is mainly composed of an inner layer, the middle layer, liquid resistance of 2 or 4 or 6 layers of spiral steel wire reinforced layer, outer layer, inner layer with the pressure transmission medium, the protection of wire is not affected by erosion, outer layer protection wire is not damaged, wire (φ 0.***2.0 reinforced steel matrix material) layer is enhanced effect of.

B, product use:

High pressure wire reinforced hydraulic hose is mainly for mine hydraulic support, the exploitation of oil fields, suitable for engineering construction, lifting transport, metallurgy forging, mining equipment, ship, injection molding machinery, agricultural machinery, machine tools and various industrial sectors mechanization, automation of hydraulic system in transportation has certain pressure (high pressure) and temperature (petroleum based such as mineral oil soluble oil, hydraulic oil, fuel, lubricating oil,) and aqueous liquid (such as emulsion, oil and water emulsion, water) and liquid transmission, high working pressure up to *****0MPa.

Note: the enterprise hose winding wire standard according to the standard of GB/T*******3, DIN****3, SAE**0R9 - *3 standard, this standard is not suitable for castor oil based and lipid based liquid

C, product features:

The 1 hose with special synthetic rubber made with, has excellent oil resistance, heat resistance, aging resistance performance.

The 2 hose high pressure bearing, pulse performance.

Closely, combining the 3 pipe body is soft, under small deformation

The 4 hose has excellent flexibility and fatigue resistance.

The 5 hose winding wire length of *0 meters, can be made upon request within fifty meters.

Four, applicable temperature: **0 °C to ***0 °C

In six, the matters needing attention:

Bending radius of 1 curvature radius should not be less than the given, prevent damage hose skeleton or because of excessive tension, early damage.

2 according to the conditions of use, the correct selection of hose varieties, specifications, do not misuse or substitute.

When using the 3 hose, pressure should be balanced to adjust, to avoid the sudden pressure increase and the damage to the pipe body.

4 the work site changes, should ground handling, can not be mopping the floor, so as not to scratch the glue, corrosion skeleton layer.

5 transport corrosive liquids, after internal should be cleaned, prevent corrosion residues long tube