The AGNEE Worm Gearboxes have Cast Iron Gear
Case of streamlined design completely air tight, dust proof and
capable of being installed in open without any cover. The Worm
Shaft is made of Alloy Steel, duly hardened and tempered. The Worm
Wheel is made of Chill Cast Phosphorous Bronze and teeth accurately
Generated on Gear Hobbing Machines. They are supported on Extra
Heavy Duty Taper Roller anti friction Bearings of ample margin of
safety to allow adequate journals as well as thrust loads.
Lubrication is effected by splash of oil from the sump. Thus, no
special care is required except for occasional oil topping to the
required level. Air cooling is effected by means of standard
polypropylene or metal fans. Please read the Selection of Correct
Worm gearbox for choosing the correct one for your
application. Right angle worm gearboxes contain input shafts
that are positioned perpendicular to the output
shafts. They are available in:
Vast range of
Models suit every individual's requirement
Some Models
like C.D. *0, *0, *5, *5, **0 mm, Ratio *0:1 or *0:1 are usually
available Ex-stock or on short notice
Center
Distances from *0 mm to **0 mm
In Single or
Double Stage Reductions
Ratios from
5:1 to ***0:1
Also made as
per customer's specifications, Drawing,
requirements
Overhauling of
Old Gear Boxes also undertaken, Early delivery
schedules
Adaptable Worm
Gear Boxes, range from CD *5mm to *5mm
