详情
The Shutter actuator is the modular
installation devices. They can be
installed in the
distribution boards on *5mm DIN rail according to EN *0 **5. The
devices adopt screw terminal
to achieve electrical connection. The
connection to the EIB/KNX bus
is established via a bus
connecting terminal. The input need connect **0V AC operating
voltage for the Shutter actuator.
It is possible that working mode of the Shutter actuator is
switched between manual operation
and automatic operation by pressing
the Man. /Auto. Button about 2s, and
the Max. /Auto LED
GVS K-BUS
KNX/EIB Shutter
Actuator
4
will display the current operating status.
Push buttons are located at the
front of the device which are
used to raise and lower the
Shutter/Blind manually, to stop the
Shutter/Blind movement and for Louvre
adjustment. The
current direction of movement or the current limit position is
displayed via LEDs.
The output contacts for the
directions UP and DOWN are
mechanically interlocked so that
voltage cannot be applied at both contacts at the same time. The
pause on change in direction can
be set via the parameters
On bus voltage recovery, the action can be set via parameter for
the Shutter actuator.
The Shutter actuator for **0V
AC drives. The following functions
can be set via the
application program:
Movement UP/DOWN
Stop/Louvre adjustment
Move into preset position (up to 2 preset positions)
Set preset position (modification of the preset position during
operation)
Move to position 0…**0%
Adjustment louvre to position 0…**0% (only Blind working
mode)
Scenes
Automatic sun protection
Monitoring of wind, rain and frost protect (cyclical)
Block
Forced operation
Status display of the current position, status display of the
current operating mode
LED display
Two operation mode, Venetian Blind and Shutter
