详情
The switch actuators are the modular installation devices, with 8
and *2 outputs for selection, using EIB bus
connection terminals to connect to
the system. The switch actuators need
to connect an extra **0V AC power
supply and provide to 4 outputs. It is able to use the Engineering
Tool Software ETS (ETS2 v1.3 or later) with a
VD2/VD3 file to allocate the physical address and set the
parameters.
If the **0V AC power supply is
not connected, all LEDs are flashing
for indicating output state on
the
device.
It is able to switch from 4 to 8 independent electrical AC loads or
three-phase loads and 4 electrical AC loads
with the same phase of the **0V AC
power supply by the switch actuators
with maximum output of *6A per
output and manual switch, as well as visible switching status via
LED indication.
There are same following programming functions for each output:
time function: on/off delay
staircase function with the warning and adjustable
staircase lighting time
scene, preset control: 8bit/1bit
logic operation: AND, OR, XOR, gate function
status response
forced operation and safe function
threshold function setup
control of electro thermal valve function
manual operation switch
indication of switch status (contact position)
