HDMI wireless video transmitter 30M Support 3D 1080P WHDI Video/Audio Signal Transmission System

Model

YT-W**0T

YT-W**0R

Supported Resolution

***0p   ***0i **0p

HDMI Interface

Support HDMI1.4A video/audio format and encrypted   video format HDCP2.0

Transmission Distance

*5m without obstacles

System   Latency

<1 ms

Antenna

Omni bearing built-in antenna

Power

**0~ **0V alternating input current, 5V 3A direct current output power adaptor

Certificates

FCC CE

standard

WHDI 1.0

Supported interface

3.5mm plug,built out infrared remote control connector

Built in infrared receiving area

Working temperature

0℃ - *0℃

Dimension

**6(L)**3(W)**5(H)mm

No video

1,   Check the status of LED, and check if the HD   media player works normally.

2. Check if the joints and wires are   damaged and make sure they are correctly connected to corresponding   interface

2,   3. Ensure there is video on   output devices.

3,   4. Check the receiver is   correctly connected to display equipment

4,   5. Make sure all devices are   working on supported distance. Draw them closer and try it again.

Power LED off

1,  Make sure the power adaptor is   correctly connected and the voltage is 5V3A

2,  Make sure the power supply would   not be interrupted.

3,  Make sure transmitter is fully   powered.

Receiver video indicating LED abnormal

1,  Make sure video and audio   signals can be transmitted to receiver successfully.

2,  If there are video and audio   signal on output devices, please check the indicating LED to see if something   got wrong with it.

3,  Make sure the device is working   within the supported distance.

Bad   picture

1. Ensure there is video on output devices

2. Check if the receiver is correctly   connected to display equipment and there is no damage on joints and wires.

3. Make sure all devices are working on   supported distance. Draw them closer and try it again.

No sound or bad sound

1. Restart the transmitter and connect it   again

2. Make sure there is no disturbance from   the same frequency (4.9～5.9GHz)within 1 meter.

Register failure

1.      Make sure the amount of registered source devices on display   equipment is less than 8.

2.      Ensure the distance between transmitter and receiver doesn't exceed   supported distance. If it does, make them closer and try it again.

Check if source device has been added on display   equipment. If it has, delete it and make registration again.

Connection failure

1.      Ensure the working distance doesn't exceed supported distance. If it   does, make them closer and try it again

2.      Make sure source devices have been registered every time after   software update.

3.      Ensure source devices and display devices have been registered.

4. If failure occurs again, delete all registered information and try   it again.

Other problems

If any other problems occur, please restart   the device and make connections again.