Rubber Silicone Stoppers Rubber Plugs Silicone Hollow Plugs Rubber Caps Rubber Washer Plugs

详情

Rubber Silicone Stoppers Rubber Plugs Silicone Hollow Plugs Rubber Caps Rubber Washer Plugs



~REFERENCE:

SC

DESCRIPTION :

Silicone Cap

MATERIAL:

High temperature Silicone

See the material data sheet

DIMENSIONAL TOLERANCE

The dimensional tolerance of the Silicone Cap is according the RMA A3

APLICATIONS:

Powder Coating, Wet Coating, E-Coating, Plating, Anodizing.

USES:

This cap is used to mask studs and bolts.

RECOMMENDATIONS for USE:

The inner diameter A should be between 0.3 and 0.5 mm below the diameter of the bolt to be

protected so the cover fits well and doesnt fall during the process.

Choose the most appropriate cover length C for the length to be hidden.

STORAGE RECOMMENDATIONS:

Storing  this  product  away  from  direct  sunlight  and  at  a  temperature  between  *0º  C  and  *5º  C  is

recommended  in  order  to  prevent  any  modifications  to  the  properties  such  as  flexibility,  elasticity  or

decolouring, among others.

The material this product is made of possesses  no health risk nor is it considered hazardous requiring

consideration when handling or storing it.

EXPIRY

This product does not expire, but it may lose plasticity and flexibility if stored inappropriately and/or for

more than 5 years.

USEFUL LIFE OF THE PRODUCT

The  useful  life  of  this  product  depends  on  the  conditions  and  loads  it  is  subjected  to  during  the

process. Chemical products may reduce the useful life of the product.