Performance and
characteristics. 1. This machine is small volume, less coverage,
easy to learn, understand and less operation with low power
consumption. 2. Frame type, hydraulic unit installed
outside. It is hydraulic machinery with high pressure,
efficient oil output, incense oil full-bodied, clean and high
quality, etc. 4. Not only manufacture all sorts of
plants oil, but also meat oil, clay, de-oiling, dehydration,
degrease all kinds of chemical raw materials. 5. This oil press except for all kinds of
vegetable oil press can also squeeze of animal oil press, clay, of
, dewatering, juice, etc. The rules of
operating: 1. Note: Before start (1) Clean inside the tank and clean the
hydraulic oil. (2) Check whether each part bolt is
loose. (3) The *5 reversing switch power
supplied by the on-board stop switch, the other three core wires
side connected to the motor, the motor need to check the rotary
direction. 2, Extraction process: (1) No load running for 1 to 2 minutes first,
such as in winter and spring, empty ***0 minutes, make the oil
diluted and ease of operation. (2) Exhaust fume from fried materials,
separate materials by plates and put to feed bucket, keep oil
surface is slightly lower than expected on the bucket; otherwise,
the oil cylinder will over travel. Push overall press under the oil
pan, cylinder alignment press oil pan, then switch on. (3)Pull out
explorers to the valve and switch on the power switch, pressure
bearing oil pan. (Cylinder telescopic by manual reversing valve,
namely when the stem to open, press will do downward movement
andvice-versa) (4) Only expert handlers allowed,
Forbidden leave away while the host is d in the process of booster,
the main motor must stops working when the pressure gauge reaches
*0 million, otherwise it will damage the hydraulic
system. (5) Start motor again after pressure
gauge callback, turn off the power supply if point to *0 MPa again,
keep it stable to *0 MPa, If material barrel oil finally no oil
come put means oil has drained. (6)Lift pressure oil pan, hang hook at
one end, the other side on the VAT, and press pressure oil pan,
lift charging barrel, pull out the oil cake. (7)Hold up oil pan, remove hook then
prepare for the second press.