SGS Cold-Applied Anticorrosion Tape Production Line

详情

This line is used to making the anticorrosion tape which is for steel pipe out anticorrosion. It includes the outer tape, inner tape and joint tape. The work from rubber, plastic granules to anticorrosion tape all will be finished in this production line.




1. Technical parameter

Width*thickness                   1200*(0.5-1.5)mm
MAX. output                        8-10 ton/24h
Total power                          ≤ 380kw
Average power                     150-160kw
Water consumption               Cycle water (outside 50 m³ water tank by customer self) 
Hydraulic pressure                 2-4kg/cm²
Air capacity                           0.3m³/h
Air pressure                           0.4-0.6 Mpa
Total size(L*W*H)                20000*7000*4000 mm
Total weight                           about 50 tons

1.1 XQ-8 cutter
Model number                        XQ-8
Cutting width                          660mm
Oil cylinder work pressure      MAX.  80KN 
Oil cylinder unit pressure         4.4MPa 
Cutting knife stroke                 580mm
Cycle period                           20-30S
Oil pump power                      5.5KW
Total size(L*W*H)                 1065×1071×2577mm
Weight                                    2200 kg

1.2 XH300 milling machine(special design) 
Kneading total capacity           300 L
Banburying total capacity         350 L
Drive power                            45 kw
Rotor speed (front/back)         0-37/0-21 r/min

1.3 XJ-115 Extruder
Screw diameter                       115 mm
Drive motor power                  1 kw
Speed                                     0-50m/min
Timing type                              By frequency

1.4 SJ-120/30 Extreder
Screw dia.                               Φ120mm
Screw L/D ratio                       30:1
Screw speed                            8-80 r/min
Drive power                            132 kw
Timing type                              Frequency control
Material of screw and barrel     38CrMoALA
Heat treatment                          Hardening and tempering HB260-290, 
Nitriding thickness                    0.4-0.7 mm 
Temperature control section      6 zones
Heating power                          6* 5 kw
Cooling fan                               6*0.37 kw
Output                                      250-300 kg/h
Change net type                        Double station, auto. By hydraulic pressure
Gear material                            20 CrMoTi
Gear surface treatment              Carburizing, quenching, hardness HRC55-60
Hydraulic pressure pump power   1.1 kw
System pressure                         ~25Mpa
Total size(L*W*H)                    4500×1200×2500
Weight                                       ~4600 kg

1.5 LM-1400 Die head
Die type                                   Clothes rack type 
Die material                             45#, hardening and tempering HB220-250
Passage surface                       Chromeplate thickness 0.03mm
Usable width                           1400mm
Temperature control section     5zones
Heating power                         18 kw
Gap width                                1.0mm
Weight                                     1600kg
1.6 YC1400 Calendering Laminate Device
Model number                         YC1400
Roller dia.                                Φ400 mm
Roller surface treatment            Chromeplate  thickness 0.03mm      
Work length                             1400 mm
Middle roller speed                  3-26.3 m/min
Timing type                              by frequency
Adjusting range                        0-10 mm
Motor power                           75 kw
Total size                                 6600×1620×2490 mm
Weight                                    18600 kg

.....................

For futher information, please contact us at any time.