**0x**0 **0x**0 **0x**0 **0x**0
**0x**0 ***0x**0
Customer sizes quoted upon
request.
INSTALLATION OF
RADIATION SHIELDING GLASS
Radiation shielding glass can not be used for exterior
applications.
· When installing, care should be taken that the sealing
agents do not contain any acid or
alkaline substances e.g. acetic acid, ammonia etc.
· Labels may cause staining on the glass surface due to
reaction of the adhesive.
· It is advisable to wear cotton gloves when handling
the glass to avoid leaving fingerprints.
CLEANING RECOMMENDATIONS FOR
RADIATION SHIELDING LEAD GLASS
General cleaning advice:
· Do not use harsh abrasive cleaning chemicals or
materials these could abrade the
surface and leave scratch marks, which can not be
removed.
· Never allow any liquid cleaning material to dry on the
glass surface this will leave water
marks on the glass surface that will be very difficult to
remove.
· Use only mild detergents.
Depending on the type of cleaning to be made, the following
recommendations are given:
· General cleaning for the removal of dust, film etc.
use a soft cotton cloth together with
isopropyl alcohol and clean in a smooth circular motion.
· Cleaning of difficult stains use a mild detergent diluted
with water to the manufacturers
recommendations and clean with a soft cotton cloth. Dry the
surfaces immediately after cleaning
with a dry cotton cloth, and using a further soft cotton
cloth, clean with isopropyl alcohol as in
section.
· The following are acceptable methods for cleaning
radiation shielding glass: water,
non-abrasive cleaning agents, spirts and hydrous emulsion of
cerium oxide (polishing grade).
