Sell EPP foam fruit box making machine

详情

Structure of machine frame

1. Whole equipment frame is welded by *6Mn(high manganese steel Q**5)
2. we make Zinc spraying layer and spray layer on the surface of whole equipment frame, which guarantees the best capability and long lifetime for anti-corrosion.
3. Frame formwork is made of 4 pcs of guide posts, every post can be independently removed and replaced, so you dont need to make an disassemble of whole equipment.
4. Adding the Balance guiding system on the movable mold, to ensure the parallel degree of movable mold running while loading the weight of movable weight, in order to ensure the distance between movable mold and fixed mold is equality, so that the thickness and size of identity mode are same.
5. Using big diameter valve can offer enough supplying capacity in an instant, to short the molding cycle time.
6. Pipeline system
7. Steam pipeline system: the steam feeding of movable mold use the ways of combined rotary assembly type, which reduce the hose using, to reduce the using cost.All valves in steam system use imported brand (GEMU of Germany).The steam feeding system of movable mold and fixed mold use *-sides feeding, to ensure the high efficient of steam feeding of equipment, also it can reduce the steam consumption at the same time.
8. Air system: the machine is equipped with air drying degreasing system, to ensure the common using and using life of air element. and all valves in air system use Germany GEMU brand.  
9. Water system: Equipment is equipped with quantitative water cylinder, to not affect the cooling efficient of equipment when the pressure of plant water system is too low.
10. Vacuum system: having separated-working high efficient cooling system, working Negative pressure can reach to be *7bar.
11. Control system
12. PLC and touch screen all use Siemens brand.
13. The controlling of steam pipeline valve all use Germany COSYS electro pneumatic digital proportional valve(with Tape positioning controller),use all Digital Proportional Pulse flowing control, pulse feeding, pulse heating.
14. parameters setting is easier, which improve production efficiency and reduce energy consumption
15. when the safe system having fault and safe door is open, the single safety control circuit will cut the PLC output power and working power of AC contactor, so the machine cant run, which ensure the safety of maintenance personnel.

1. Other advantages

1. Use two halves type axle sleeve and bearing shells, the material of bearing shell is oil contained nylon, which is easy to have lubrication and exchange
2. With more large-diameter inlet steam pipes, to achieves evenly heating.
3. Symmetrical hydraulic cylinder use propelling mold-locking, easy to move and short the time of open/close the mold.
4. Equipment control system use full digital proportional control, having an precise control of prod5.uction energy consumption.
5. Using big diameter valve can offer enough supplying capacity in an instant, to short the molding cycle time.
6. Steam room use special Thermal insulation material, realize the insulation, heat insulation of mold cavity.
7. the main rod can be disassembled independently.