100% platinum catalyst rtv2 liquid silicone 3D chocolate candy molds

详情

Feature of **0% platinum catalyst rtv2 liquid silicone 3D chocolate molds :

1.FDA & ROHS certificate.

2.No limitation with product thickness .Can do deep curing .

3.High temperature resistance (can reach 0~**0 degrees ) ,acid and alkali-resistance and aging resistance

4.Light viscosity and good flowability .easy for pouring operation .

5.Can be cured both at room temperature or be heated

6.Low shrinkage .The shrinkage rate is less than 0.1%.

7.Favorable tensile and tear strength

8.High duplication times .aging -resistance

9.Tasteless.no flammable,safe and reliable

*0.Customize as you need

Application of **0% platinum catalyst rtv2 liquid silicone 3D chocolate molds :

cake molds, cookie molds, chocolate molds, candy molds etc.

Operation instructions of **0% platinum catalyst rtv2 liquid silicone 3D chocolate molds :
Step 1: prepare the original molds
Prepare an perfect original mold and clean it totally before operation .
Notes :Make sure your original molds and operation tool cleaned up totally to avoid uncure problem .

Step 2: Take **0 G part A and **0 G part B (Or **0 G part A and *0 G part B) and mix them evenly.
Notes: Addition cure mold making silicon rubber is two part flowing liquid , Pls follow the step strictly:
1.Weigh the two part exactly by electronic weight..
If any part not in exactly weight , it may cause changing of hardness , or even cause no cure problem.
2.Mix part A and part B evenly.
Otherwise the silicon rubber will be partly solidified and this will give birth to difficulties in your final operation.
Whats more, the finished molds will meet a short life. All of these will cause a waste of silicon rubber.
Step 3: Vacuum pumping
Without exception, this step takes less than *0 minutes.
Otherwise, it will cause cross linking reaction, and no more further steps will be available.

Step 4: Pouring casting or Brush operation
Notes:1. For simple pattern products we suggest use pouring operation way , which will be very easy to operate and de-mould.
Pourable silicone require light viscosity which will be easy to flow smoothly and easy to de-air .
2.For delicate pattern products we suggest use brushing operation way , which can copy the pattern exactly .
Brush silicone require high viscosity which wont be easy to flow away and easy to brush .
3. We suggest to set the silicone mold for another *2 hours after de-mould before put into large production .

Warm tips :
As rtv2 liquid silicone is a kind of platinum cure system , which will be easy to cause no cure problem ,soKindly follow the tips below :
Do not mix with liquid condensation silicone rubber or even the tool which used for condensation silicone
Do not mix with organic matter which contains N, S, P organics and ionic compound like Sn, As, Hg, Ph,
Do not add any pigment or powder into the addition cure silicone rubber without any testing to prevent no cure problem