polyurea coating used for floor, furniture, foam sulpture

Application

Designed for use as a smooth seamless waterproof lining coating system for interior and a roof and wall coating system for exterior applications. Ideally suitable for use in areas including:

Metal, concrete, wood and foam roofing.

• Mechanical rooms.
• Cold storage areas.
• Basing and reservoirs.
• Marine bridges.
• Tunnels.
• Underground engineering.
• Cooling towers of power plants.
• Aquarium lining.
• Pond lining.
• Water and waste water linings. 

1. Curing speed, in the vertical plane will not produce sagging, cross-linking speed of **6 s, **9s can reach the level of non-stick hand, *0s can walk on it. *0min to put into use.

2 is not sensitive to temperature and humidity, high humidity and low temperature on the polyurea elastomer coating performance is quite small.

3 **0% solid content, two-component coating, single coating system, spray coating can reach a fairly thick ***0UM above, without solvent, zero VOC.

4. Outstanding physical properties, tensile strength ****1MPA, stretching 2% - **0% between.

5, heat resistance, thermal stability of **7 degrees, (**0T)

6. Compatibility with the pigment is very good, you can adjust the color.

7. Adjustable formula, from soft to hard polymer coating.

8. Can be enhanced, in the spraying process can be added to enhance the glass fiber.

 

Packing

Part A: **0kg /drum

Part B: **0kg/drum

Storage condition

• A component is easily affected by moisture must be protected from moisture contamination. Containers are factory sealed with an inert gas to prevent contamination. Keep all containers tightly closed during storage. For further storage after opening, containers must be purged with nitrogen gas or dry air and tightly sealed from moisture.
• Store drums and pails in a cold, dry and ventilated location between ****0°C.
• Keep away from rain and sunshine.
• Keep away from fire and heat source.
•  

Installation instruction

a. Surface preparation

Surface must be properly prepared. Remove all oil, dust, grease, dirt etc to ensure adequate adhesion.

b. Application condition

Temperature:

Air and surface: **0°C**0°C

Relative humidity: ≤*0%