ADVANTAGE
1. The brass separator and water collector of monomer forging and
pressing make the distribution of chilled water in and out of coil
more uniform and the flow resistance less, give full play to the
whole efficiency of heat exchanger and greatly reduce the flow
resistance of water system
2. The end plate and deflector plate of the volute are connected by
toothed way, which overcomes the defects of air leakage and easy
rust of the electric welding connection.
3. The shell body of the unit is formed by stamping and bending of
high strength galvanized steel plate with strong anticorrosion
ability.The inner wall of the roof is pressed with a hot pressing
PE insulation cotton to prevent the phenomenon of cold bridge.The
bottom of the water tray is wrapped with PE insulation cotton,
which is formed by primary hot pressing.
4. The optimized design of the drain port of the condensate tray
can discharge the condensed water generated during the operation of
the unit to the maximum extent and greatly reduce the breeding of
bacteria and microorganisms.
