Details of GoodsSpecification
of sscnetiii / h mr-j***0b for Mitsubishi servo amplifier
**0W:
[output]
. rated voltage: three-phase ac**0v
. rated current: 1.5A
[main circuit power input]
. power frequency: three-phase or single-phase ac**0v ~ **0V *0Hz /
*0Hz
. rated current: 1.5A
. allowable voltage variation: three-phase or single-phase ac**0v ~
**4v
. allowable frequency variation: ± 5%
. capacity of power supply equipment: 0.5kva
. surge current: *0A (reduced to about 3A after *0ms)
[control circuit power input]
. power frequency: single phase ac**0v ~ **0V *0Hz / *0Hz
. rated current: 0.2A
. allowable voltage variation: three-phase or single-phase ac**0v ~
**4v
. allowable frequency variation: ± 5%
. power consumption: *0
. surge current: *0 ~ *0A
[power supply for interface]
. voltage? Frequency: DC*4V ± *0%
. power capacity: 0.3A (including CN8 connector signal)
[control mode] sine wave PWM control current control mode
[dynamic brake] built in
[communication function]
. USB: connection with personal computer, etc. (corresponding to Mr
configurator2)
[position control mode]
. maximum input pulse frequency: 4mpps (differential input),
**0kpps (open collector input)
. positioning feedback pulse: encoder resolution (resolution of
servo motor per revolution) *2 bits
. command pulse magnification: electronic gear A / b times a = 1 ~
*******6, B = 1 ~ *******6, 1 / *0 < A / b < ***0
. positioning completion pulse width setting: 0pulse ~ ± ****5pulse
(command pulse unit)
. excessive error: ± 3 Revolutions
. torque limit: set through parameter setting or external analog
input (dc0v ~ + *0V / maximum torque)
[speed control mode]
. speed control range: analog speed command 1:***0, internal speed
command 1:***0
. analog speed command input: dc0v ~ ± *0V / rated speed (the speed
at *0V can be changed through [pr.pc*2])
. speed change rate: ± 0.*1% (load change: 0% ~ **0%), 0% (power
change: ± *0%) ± 0.2% (ambient temperature: *5 ± *0 ℃). Only when
analog speed command is available
. torque limit: set through parameter setting or external analog
input (dc0v ~ + *0V / maximum torque)
[torque control mode]
. analog torque command input: dc0v ~ ± 8V / maximum torque (input
impedance: *0K? ~ *2K?)
. speed limit: set through parameter setting or external analog
input (dc0v ~ ± *0V / rated speed)
[protection function]
Overcurrent protection, regenerative overvoltage protection,
overload protection (electronic thermal relay), servo motor
overheating protection
Encoder abnormal protection, regeneration abnormal protection,
insufficient voltage protection, instantaneous power failure
protection
Overspeed protection and excessive error protection
[safety function] sto (IEC / en ********2)
[safety performance]
. third party certification specification: EN ISO ******1 type 3 PL
D, en ****8 SIL 2,
EN ****1 SIL CL2，EN ********2 SIL 2
. response performance: less than 8ms (STO input off → energy
cut-off)
. test pulse input (STO): test pulse cycle: 1Hz ~ *5Hz test pulse
off time: max. 1ms
[structure (protection level)] self cooling | open (IP*0)
[compact installation] adjustable
[weight] 0.8kg
