10M Media Converter

详情

APT***3S*6OC Dual Fiber Dual-Direction Fiber Optic Media Converter The Converter have been tested and found to comply with the limits for a class a distal device, pursuant to part *5 of the FCC Rules. These standards are designed to provide reasonable protection against harmful interference when these devices are operated in a commercial environment. These devices can use, generate and radiate radio frequency energy and may cause harmful interface to radio communications unless installed in accordance with User's Guide. Operation of this device in a resifential area is likely to cause harmful interface which will make the user responsible for the appropriate remedial action at this expanse. These are class A products In a domestic environment these products may cause radio interface in which cause the user will need to consider adequate preventative measures. Technical parameter 1. Standards: IEEE**2. 3u Fast Ethernet *0/**0Base-TX and **0Base-FX 2. Connectors: (RJ**-UTP and Fiber SC) 3. LED: Power. FDX/Col, FX-Link/Act, TX Link/Act, FX**0. TX**0 4. Data Transfer Mode: *0/**0Mbps 5. Duplex Mode: Full or Half Duplex Mode 6. Power requirement: AC *-* *@********************rature: 0º C - *0º C 8. Humidity: 5% - *0 %( no condensing) 9. Cable: Cat. 5 UTP cable *0. Fiber: Multi-mode *1. Size: *4mm**0mm**6mm (L*W*H) Specification Connector Type: SC Typical Distance: *0Km Fiber Type: Single mode Wavelength: ***0nm Min TX PWR: *5. 0dBm Max TX PWR: *1. 0dBm Sensitivity: **5. 0dBm Link Budget: *9. 0dBm Note 1. Optical port working mode is **0M full-duplex, LAN port is Auto Negotiation. 2. When twisted-pair interface initialization, warrant to check couple equipment's state to set it self�s state, if can't check out opponent state that the state is uncertainty. 3. Don't use your unaided eyes to look at the TX fiber transmit port when the media converter's state is electrify. 4. Please put dustproof cover on fiber optic media converter when is not used. 5. When the product connecting with other equipment (router, switch, HUB, NIC), the interconnection equipment's optical interface's speed and mode must be consistent. (Multimode and single mode) Interconnection equipment's LAN port's speed should mismatch. (**0Base-TX/**0Base-T). 6. This product must pay attention to connecting origin end media converter's TX port's wire jumper with connecting far end media converter's RX port. Origin end media converter's RX port's wire jumper must be connecting with far end TX port. Don't connect wrong.