PLUSCOAT PLUSTONE INTERIOR WALL PAINT

详情

PLUSTONE A*1
PREMIUM QUALITY INTERIOR MATT PAINT
PLUSTONE A*1 is a premium quality, wet scrub resistant, waterproofing, interior use, matt emulsion paint. It can be applied on concrete, plaster, brick, masonry surfaces, plywood, anti-rust primed steel, etc.  It has anti-bacterial properties, which give to material a mould resistance. PLUSTONE A*1 is available in an attractive range of colours and offers the advantages of low material consumption and a high quality professional finish.
PROPERTIES: PLUSTONE A*1 provide excellent hiding power, perfect water vapour permeability and low consumption, which makes material highly economical in long term of exploitation. PLUSTONE A*1 contains high quality polymer resins to ensure excellent resistance. Formulate without using of solvent and any other hazardous additives, which makes material environmentally friendly.
AREA OF USE: PLUSTONE A*1 suitable for high quality interior painting works of plaster, concrete, filler treated brick, cardboard, wooden surfaces, also for gypsum board, chipboard and wooden fibre board surfaces. Suitable for new and previously painted surfaces. Interior walls and ceilings in premises in which high wear resistance is required such as lobbies, staircases, corridors, patient rooms and other surfaces which are subject to higher than normal stress.  
PREPARATION OF SURFACE: All dust, dirt and foreign matter should be scraped and brushed away.  Also the surfaces should be free from salts, oil, grease and ridges. Before applying to old surfaces, ensure the substrate is firm.  First wash down the old surface with a sugar-soap solution, rinse and allow drying before repairing or applying the primer. Protect all adjacent surfaces not to be covered.  All cracks, chips, voids and damages should be repaired using PLUSPLAS repair mortars or PLUSSPAC plasters. Prime all untreated surfaces with a PLUSPRIME or PLUSBOND primer.
APPLICATION: Stir well before use. The application surfaces and area should be over *5°C. PLUSTONE A*1, diluted with clean water in ****0%, applying in 2 coats by the roller, brush or spray.  Leave 2 to 4 hours between coats. Reserve enough material for one uniform surface and mix into one can to avoid possible colour differences. Clean tools and equipment with water after use.
CONSUMPTION: 0.****0.**0 L/m2 in 2 coats of application.
HEALTH & SAFETY: Keep out of reach of children. Avoid contact with skin and eyes.  In case of contact with skin, wash down with clean water.  In case of contact with eyes, rinse immediately with plenty of clean water and seek medical advice.  Use in a well ventilated area. 
PACKAGING & STORAGE: PLUSTONE A*1 is supplied in *5 and 4 L plastic pails. Store material in a clean dry area, protected from direct sunlight and extreme heat and cold. Unopened containers can be stored for *2 months.  Use the oldest material first.
RECYCLING: Empty cans should be recycled or disposed of in accordance with local regulations. Liquid waste should be destroyed according to the local regulations. For packaging recycle type look on a bottom of pails.
TECHNICAL DATA
Product              Premium quality interior matt emulsion paint
Binder               Acrylic polymers
Colour                Colour chart of PLUSCOAT
Diluting              ****0% with water
Specific gravity 1.5
Consumption    0.****0.**0 L/m2 in 2 coats
Application        Roller, brush, airless spray
Drying time       **4 hours between coats, deep drying in *4 hours.
Packaging           *5 and 4 L plastic pails
Storage               *2 months in the original unopened tare