Structural Washers, DIN 6916 / EN 14399 Part 6

详情

Structural Washers, DIN ***6 / EN ****9 Part 6

1. Description
The information below lists the required dimensional, chemical and physical characteristics of Hardened&Structural Washers, DIN***6/EN****9 Part 6, in this purchase order.  If the order received does not meet these requirements, it may result in a supplier corrective action request, which could jeopardize your status as an approved vendor.  Unless otherwise specified, all referenced consensus standards must be adhered to in their entirety.

2.Specification 
1) Dimensions and Workmanship:DIN ***6，EN ****9 Part 6
2) Material and Mechanical Properties:
     Carbon Steel quenched and tempered to ******0 HV (Approximate conversion ****0 HRC)3)
3) Available Finishes:
     Plain w/light protective oil
     Hot Dip Galvanized (HDG)
     Dacromet
     Customized.
4) Material Test Report 
The MTR must have documented lot traceability, including full chemical and mechanical figures, to the specification(s) above.

3.Profile Drawing
can be found below