详情
need to use the modules and components:
• Arduino Mega***0 MPU (The kit contains): This is a 3d printer
brain responsible for controlling the entire printer to perform
certain actions, such as printing specific documents;
• RAMPS1.4 (The kit contains): This is the main board above the
expansion board with it in order to better connect with other
hardware and controls, play a role in the transition of the
bridge;
• A***8 stepper motor driver board (The kit contains): This is used
to connect the stepper motor control board in order to achieve
control of the stepper motor, to achieve XYZ and extruder
action;
4 to 5 stepper motors (The kit not included): This is the power
part of the 3d printer, driven by the A***8 board control, the
motor is connected to the RAMPS1.4 board;
Heating head (The kit not included): thermal head is used to melt
the printing material (ABS, PLA, etc.), the general thermal head
has two electrical components, energized after an electric wire can
be used to heat, similar to an electric furnace, Another is a
thermistor, is used to get the current temperature is how much
heating the head in order to achieve better temperature control,
due to the firmware temperature Gets success before allowing many
operations, so even a simple test also needs to connect the two
thermistor (the other is used to get hot bed temperature)
Hot Bed (heatbed) (This kit is not included): When printing ABS, to
let invariance and the first layer easily stick to the platform,
the general solution is to use hot bed, hot bed also contains two
parts, heating parts and the thermistor, which thermistor is
required;
*2V power supply (The kit not included): In order to be able to
drive the motor and the circuit board, you need your own power with
a *2V **0W ~ **0W or so.
