New 7.70 Meter Steel Work /Tug Boats built to order

详情

Specifications for 7.*0 Meter Steel Work / TUG Boat
Vessel Outline:
The vessel is designed as a single screw steel mono hulled workboat for operation on coastal seas, rivers and estuaries.
The vessel is designed in order that it can operate as a Tug Boat/ Line Handling, and Safety Boat.
4 lifting lugs situated on the associated transverse frame, welded to the deck and the low side coaming.
I would envisage a large shackle onto these lugs with the lifting straps through the shackle.
The lugs can be any sort of size or shape as required.
Water tight compartments for extra buoyancy **0 x *0mm D fender & solid rectangler fenders around the gunwale and down the stem & on pusher bow.
Specifications:
L.O.A: 7.*0 Meter (Including fender)
L.O. Hull : 7.*0 Meter
L.W.L: 6.*0 Meter
BEAM: 3.*0 Meter
DRAFT (Hull): 0.*4 Meter (Fully Loaded)
DISPLACEMENT: ***0Kg (Fully Loaded)
Fuel: **0 Litres
Max B.P: ***0 Kg
Max Speed: *0/*2Knots
Hull Plating: 6mm Hull /Deck/Wheelhouse & Coaming
Engines & Machinery:
Engine & Gearbox:
FPT N**- M*0 **9kW / **0HP Marine Diesel Engine
Gearbox, ZF **0 Ratio 2.**8:1
FPT: Deluxe Control Panel and 6m loom
Flexible mounts
*2 volt electric start and *0 amp alternator
Sump drain pump
R & D flexible coupling
Vetus: Exhaust silencer
Vetus: Flexible fuel pipes
Vetus: Fuel delivery and leak off kits
Vetus Diesel Fuel Filter
FPT: Single lever control 2 x 6m cables
On board spares kit comprising:
2 x oil filters
1 x fuel filter
1 x air filter
1 x belt
Propeller:
Teignbridge *0 diameter x 3 blade.
Aquapoise design.*5% DAR.
Cast in Aluminium Bronze, BS***0.
Supplied fully machined, balanced & fine disc finished.


Tail shaft assemblies :
1.5 diameter x ***0mm overall length.
Material:TEMET *5, double tapered for reversibility.
C/w: keys, coupling nut & propeller nut.
Tapered half coupling assemblies.
Machined to suit output gear flange.
Stern tubes :
Length: ***0mm
Material: Mild Steel Style: Water Lubricated
The Stern tube will be fitted with half forward and a full aft brass water lubricated bearings.
Sealing is to be achieved by Tides Marine seal assembly.
Rudder assemblies: Fabricated **6 stainless steel plate.
F*1 Duplex Rudder stock and tiller arm.
Stainless Steel rudder tube c/w bearings and seals.
Fit Out:
The fore deck locker is access through the bulkhead that is split by the fwd bollard, small door each side
The engine box hinges up
Inside the forward wheelhouse & console would be the start battery, etc.
Wooden Benches fitted as required
Additional Equipment:
Propeller guard
Pusher Bow
Stern Rollers
Vetus Hydraulic Steering
Kort Nozzel or Similar
Rope Cutter
Electronics & Safety Equipment:
Garmin VHF **0i DSC VHF Radio D Type
*0kg anchor and chain
4 Solas Life Jacke